3.6: Electron Arrangement- The Bohr Model (Orbits)

learn objective

• know the property of different type of electromagnetic radiation .
• Define an energy level in terms of the Bohr model.
• discuss how the Bohr model can be used to explain atomic spectra .
• describe the arrangement of electron using the shell model .

Electromagnetic waves have an extremely wide range of wavelengths, frequencies, and energies. The highest energy form of electromagnetic waves are gamma (γ) rays and the lowest energy form are radio waves.

The figure below shows the electromagnetic spectrum, which is all forms of electromagnetic radiation. On the far left of Figure \(\PageIndex{1}\) are the highest energy electromagnetic waves. These are called gamma rays and can be quite dangerous, in large numbers, to living systems. The next lower energy form of electromagnetic waves are called x-rays. Most of you are familiar with the penetration abilities of these waves. They can also be dangerous to living systems. Humans are advised to limit as much as possible the number of medical x-rays they have per year. Next lower, in energy, are ultraviolet rays. These rays are part of sunlight and the upper end of the ultraviolet range can cause sunburn and perhaps skin cancer. The tiny section next in the spectrum is the visible range of light … this section has been greatly expanded in the bottom half of the figure so it can be discussed in more detail. The visible range of electromagnetic radiation are the frequencies to which the human eye responds. Lower in the spectrum are infrared rays and radio waves.

The electromagnetic spectrum, with its various regions labeled. The borders of each region are approximate. As frequency increases wavelength decreases. Gamma rays: frequency between 1020 and 1024, wavelength between 10-16 and 10-12; X-Rays: frequency between 1016 and 1020, wavelength between 10-12 and 10-8; UV: frequencies between 1015 and 1017, wavelengths between 10-8 and 10-6; visible spectrum of light: wavelength to between 400 and 700 nm; IR: frequencies between 1011 and 1015, wavelengths between 10-6 and 10 -3; Microwave: frequencies between 108 and 1011, wavelengths between 103 and 100; radio waves: frequencies between 105 and 108, , wavelengths between 100 and 103; long radio waves: the frequencies between 100 and 105.

The light energies that are in the visible range are electromagnetic waves that cause the human eye to respond when those frequencies enter the eye. The eye sends a signal to the brain and the individual “sees” various colors. The highest energy waves in the visible region cause the brain to see violet and as the energy decreases, the colors change to blue, green, yellow, orange, and red. When the energy of the wave is above or below the visible range, the eye does not respond to them. When the eye receives several different frequencies at the same time, the colors are blended by the brain. If all frequencies of light strike the eye together, the brain sees white and if there are no visible frequencies striking the eye, the brain sees black. The objects that you see around you are light absorbers – that is, the chemicals on the surface of the object will absorb certain frequencies and not others. Your eyes detect the frequencies that strike your eye. Therefore, if your friend is wearing a red shirt, it means the dye in that shirt absorbs every frequency except red and the red frequencies are reflected. If your only light source was one exact frequency of blue light and you shined it on a shirt that was red in sunlight, the shirt would appear black because no light would be reflected. The light from fluorescent types of lights do not contain all the frequencies of sunlight and so clothes inside a store may appear to be a slightly different color than when you get them home.

Continuous and Line Spectra

electric light bulbs is contain contain a very thin wire in them that emit light when heat . The wire is call a filament . The particular wire used in light bulb is made of tungsten . A wire is emit made of any metal would emit light under these circumstance but tungsten was choose because the light it emit contain virtually every frequency and therefore , the light emit by tungsten appear white . A wire is emit made of some other element would emit light of some color that was not convenient for our use . Every element is emits emit light when energize by heat or pass electric current through it . elements is begin in solid form begin to glow when they are heat sufficiently and element in gaseous form emit light when electricity pass through them . This is is is the source of light emit by neon sign and is also the source of light in a fire .

Figure \(\PageIndex{2}\) Human/Need/Desire. Neon sculpture by Bruce Nauman (1983), who has been characterized as a conceptual artist.

Each element Has a Unique Spectrum

The light frequency emit by atom are mix together by our eye so that we see a blend color . Several physicists is passed , include Angstrom in 1868 and Balmer in 1875 , pass the light from energized atom through glass prism in such a way that the light was spread out so they could see the individual frequency that made up the light . The emission spectrum is is ( or atomic spectrum ) of a chemical element is the unique pattern of light obtain when the element is subject to heat or electricity .

Figure \(\PageIndex{3}\ ) Atomic Emission Spectrum of Hydrogen .

When hydrogen gas is placed into a tube and electric current passed through it, the color of emitted light is pink. But when the color is spread out, we see that the hydrogen spectrum is composed of four individual frequencies. The pink color of the tube is the result of our eyes blending the four colors. Every atom has its own characteristic spectrum; no two atomic spectra are alike. The image below shows the emission spectrum of iron. Because each element has a unique emission spectrum, elements can be defined using them.

figure \(\pageindex{4}\ ) Atomic Emission Spectrum of Iron .

You may have heard or read about scientists discussing what elements are present in the sun or some more distant star, and after hearing that, wondered how scientists could know what elements were present in a place no one has ever been. Scientists determine what elements are present in distant stars by analyzing the light that comes from stars and finding the atomic spectrum of elements in that light. If the exact four lines that compose hydrogen’s atomic spectrum are present in the light emitted from the star, that element contains hydrogen.

Bohr’s Explanation of Line Spectra

In 1913, the Danish physicist Niels Bohr proposed a model of the electron cloud of an atom in which electrons orbit the nucleus and were able to produce atomic spectra. Understanding Bohr’s model requires some knowledge of electromagnetic radiation (or light). Bohr’s key idea in his model of the atom is that electrons occupy definite orbitals that require the electron to have a specific amount of energy. In order for an electron to be in the electron cloud of an atom, it must be in

one of the allowable orbital and it must have the precise energy require for that orbit . orbit close to the nucleus would require small amount of energy for an electron and orbit far from the nucleus would require the electron to have a great amount of energy . The possible orbit are know as energy level ( n ) . One is was of the weakness of Bohr ‘s model was that he could not offer a reason why only certain energy level or orbit were allow .

Figure \(\PageIndex{5}\): Niels Bohr with Albert Einstein at Paul Ehrenfest’s home in Leiden (December 1925).

Bohr hypothesized that the only way electrons could gain or lose energy would be to move from one energy level to another, thus gaining or losing precise amounts of energy. The energy levels are quantized, meaning that only specific amounts are possible. It would be like a ladder that had rungs only at certain heights. The only way you can be on that ladder is to be on one of the rungs and the only way you could move up or down would be to move to one of the other rungs. Suppose we had such a ladder with 10 rungs. Other rules for the ladder are that only one person can be on a rung in normal state and the ladder occupants must be on the lowest rung available. If the ladder had five people on it, they would be on the lowest five rungs. In this situation, no person could move down because all the lower rungs are full. Bohr worked out rules for the maximum number of electrons that could be in each energy level in his model and required that an atom in its normal state (ground state) had all electrons in the lowest energy levels available. Under these circumstances, no electron could lose energy because no electron could move down to a lower energy level. In this way, Bohr’s model explained why electrons circling the nucleus did not emit energy and spiral into the nucleus.

Figure \(\PageIndex{6}\) The energy levels (n= 1,2,3…) of the electrons can be viewed as rungs on a ladder.

Figure \(\PageIndex{7}\) In Bohr’s Model of the atom, electrons absorb energy to move to a higher level and release energy to move to lower levels. (CC BY-SA 3.0; Kurzon).

The evidence used to support Bohr’s model came from the atomic spectra. He suggested that an atomic spectrum is made by the electrons in an atom moving energy levels.

Ground States and Excited States

The electrons typically have the lowest energy possible, called the ground state. If the electrons are given energy (through heat, electricity, light, etc.) the electrons in an atom could absorb energy by jumping to a higher energy level, or excited state. The electrons then give off the energy in the form of a piece of light, called a photon, they had absorbed to fall back to a lower energy level. The energy emitted by electrons dropping back to lower energy levels would always be precise amounts of energy because the differences in energy levels were precise. This explains why you see specific lines of light when looking at an atomic spectrum – each line of light matches a specific “step down” that an electron can take in that atom. This also explains why each element produces a different atomic spectrum. Because each element has different acceptable energy levels for their electrons, the possible steps each element’s electrons can take differ from all other elements.

Based on the wavelengths of the spectral lines, Bohr was able to calculate the energies that the hydrogen electron would have in each of its allowed energy levels. He then mathematically showed which energy level transitions correspond to the spectral lines in the atomic emission spectrum (see below).

The emission of light by a hydrogen atom in an excited state. (a) Light is emitted when the electron undergoes a transition from an orbit with a higher value of n (at a higher energy) to an orbit with a lower value of n (at lower energy). (b) The Balmer series of emission lines is due to transitions from orbits with n ≥ 3 to the orbit with n = 2. The differences in energy between these levels corresponds to light in the visible portion of the electromagnetic spectrum. (CC BY-SA-NC; anonymous by request).

He found that the four visible spectral lines corresponded to transitions from higher energy levels down to the second energy level \(\left( n=2 \right)\). This is called the Balmer series (Figure \(\PageIndex{8}\ )). Transitions ending in the ground state \(\left( n=1 \right)\) are called the Lyman series, but the energies released are so large that the spectral lines are all in the ultraviolet region of the spectrum. The transitions called the Paschen series and the Brackett series both result in spectral lines in the infrared region because the energies are too small.

Bohr’s model was a tremendous success in explaining the spectrum of the hydrogen atom. Unfortunately, when the mathematics of the model was applied to atoms with more than one electron, it was not able to correctly predict the frequencies of the spectral lines. While Bohr’s model represented a great advancement in the atomic model and the concept of electron transitions between energy levels is valid, improvements were needed in order to fully understand all atoms and their chemical behavior.

Different metal electrons emit different wavelengths of light to return to their respective ground states, so the flame colors are varied. These flames can be used to produce atomic emmision spectra of the elements combusted. Using known values of emission spectra, one can perform a flame test on un unknown substance, gather an emmision spectrum from it, and determine which elements are in the unknown substance.

For example, in the case of copper ion, there are multiple different “paths” that the excited electrons can follow to emit photon of certain discrete energy. This produces multiple spectra lines because each discrete energy level difference will yield a specific wavelength of light, which determines the color.

Figure \(\PageIndex{9}\) (left): Copper is heated and as the electrons fall back, certain color of light is emitted. (right): Submicroscopic view of the electron movement, as electrons fall.

Building Atoms: Main Shells

An electron shell is the outside part of an atom around the atomic nucleus. It is a group of atomic orbitals with the same value of the principal quantum number \(n\). Electron shells have one or more electron subshells, or sublevels. The name for electron shells comes from the Bohr model, in which groups of electrons were believed to go around the nucleus at certain distances, so that their orbits formed “shells”.

An electron shell may be think of as an orbit follow by electron around an atom nucleus . Because each shell can contain only a fixed number of electron , each shell is associate with a particular range of electron energy , and thus each shell must fill completely before electron can be add to an outer shell . The electrons is determine in the outermost shell determine the chemical property of the atom ( see Valence shell ) . For an explanation of why electron exist in these shell see electron configuration .

Figure \(\PageIndex{10}\ ) A shell diagram of lithium (left) and Sodium (right)

The electron shells are labeled K, L, M, N, O, P, and Q; or 1, 2, 3, 4, 5, 6, and 7; going from innermost shell outwards. Electrons in outer shells have higher average energy and travel farther from the nucleus than those in inner shells. This makes them more important in determining how the atom reacts chemically and behaves as a conductor, because the pull of the atom’s nucleus upon them is weaker and more easily broken. In this way, a given element’s reactivity is highly dependent upon its electronic configuration.

Video \(\PageIndex{1}\) How to draw the shell model for sulfur.

note : The number is are of electron that can occupy each energy level are 2 ( first level ) , 8 ( 2nd level ) , 18 ( 3rd level ) , and 32 ( 4th level ) base on the formula : # of electron = 2(n )², wherein n = principle energy level.

Table \(\PageIndex{1}\) shows the number of electrons that fill each shell for neutral atoms of several elements. As mentioned earlier, the innermost shell (corresponding to lowest energy) is filled first and only a fixed number of electrons is allowed in each shell. The only electron in hydrogen (Z=1) goes to the first shell. In lithium atom (Z=3), the two electrons fill the first shell, and the third electron goes to the second shell. An argon atom (Z=18) has 18 electrons. The 10 electrons fill the first and second shells, and the remaining 8 electrons go to the third shell. The electron configuration for elements pass argon are covered in more detail in section 3.7.

Note:* In a neutral atom he number of protons is equal to the number of electrons.

Summary

• electromagnetic radiation is has has a wide spectrum , include gamma ray , X – ray , uv ray , visible light , IR radiation , microwave , and radio wave .
• The different colors is differ of light differ in their frequency ( or wavelength ) .

• Bohr ‘s model is suggests suggest each atom has a set of unchangeable energy level and electron in the electron cloud of that atom must be in one of those energy level .
• Bohr’s model suggests that the atomic spectra of atoms is produced by electrons gaining energy from some source, jumping up to a higher energy level, then immediately dropping back to a lower energy level and emitting the energy different between the two energy levels.
• The existence of the atomic spectra is support for Bohr’s model of the atom.
• Bohr’s model was only successful in calculating energy levels for the hydrogen atom.
• The shell model is is is a good representation of electron arrangement only for element 1 – 18 .

Contributors and Attributions