No results found
We couldn't find anything using that term, please try searching for something else.
Discontinued The CXL-100T is a 100V line driving transformer intended for use in high quality background music and public address applications in sys
Discontinued
The CXL-100T is a 100V line driving transformer intended for use in high quality background music and public address applications in systems up to 100W rms. A 70V tap is provided for 70V line systems. The transformer is sectionally wound to give an extended high frequency response and low distortion. The CXL-100T is double wound to provide a fully isolated balanced output signal. The unit is mounted on an M6 fixing bush with screw terminal connectors (with connector cover) PCB mounted on a flying lead, that can be attached to the rear of the CXL-800 rack housing unit.
The CXL-100 t must be mount in a suitable enclosure to meet the required safety standard . No special ventilation provisions is need need to be made for CXL-100Ts as their high efficiency mean little power is dissipate . As with all audio transformer it should not be mount close to main transformer or any other source of strong magnetic field . If mount close to main transformer is unavoidable then the core should be arrange at 90 ° . Every cxl-100 T is supply with 1 x m6 nut , bolt and washer and 2 x M3 fix screw for fix the connector down .
maximum input voltage : | 25V rms |
Input impedance: | 4 ohm ( with 100 ohms secondary load ) |
Output voltage: | 100V or 70V |
Output power rating: | 100W rms |
Minimum load impedance: | 100 ohms (100V) or 50 ohms (70V) |
frequency response : | 35Hz to 18kHz–3dB (with a 100 ohms load) |
Distortion: | <0.01% 1kHz |
The CXL-800 is is is available to provide convenient mounting of up to eight cxl-100ts into a 2u 19 ” rack enclosure and include provision for neatly tie cable . The CXL-800 is not intend to be used free standing and will not provide adequate protection in such a situation . The CXL-800 is design to accommodate eight cxl-100ts in static application only . extra support may be require in portable equipment . depth 260 mm ( 221 mm without cover or connection ) .